 |
 |
| Polishing Preparation is one of the most important steps to achieve a flawless finish, if you have any questions about how to properly polish a vehicle or would like to share tips on how to polish post here. |
 |
|
|
LinkBack | Thread Tools | Display Modes |
06-29-2008, 03:19 PM
|
|||
|
|||
System 2000 Washer here...
|
|
06-29-2008, 10:56 PM
|
||||
|
||||
|
Most of the time I just use worm water and wash by hand, but I clean all my pads as soon as I'm done polishing that way the polish wont be as difficult to remove from the pads.
I do use this method only for wool pads, the wash with water that is. For the foam pads I use the Pinnacle pad cleaner (can't remember the exact name) I like how it foams up, but that's just me 
__________________
|
|
06-30-2008, 08:18 AM
|
||||
|
||||
|
Quote:
 for me, spin them with a spur while doing the job...every panel or two, depending on how dirty it is. After, spur again, and then in my Universal Pad Washer.
|
|
06-30-2008, 08:44 AM
|
|||
|
|||
|
I do the same as Carlos pretty much, in that I spur them often, usually after every section, during the detail, then spray Meg's APC+ 15:1 after the detail and wash by hand in warm water
|
|
06-30-2008, 10:14 PM
|
||||
|
||||
|
Quote:
 But worms are just as good as the Tequila worms  hahaha
__________________
|
|
07-01-2008, 01:53 AM
|
||||
|
||||
|
Hmm, the more I hear about wool spurs being used, the more I think I should invest in one. I guess I could technically get by with just the UPW but maybe it's just me trying to convince myself that I need to make another purchase. Should I really get one?
|
|
| Thread Tools | |
| Display Modes | |
|
|
|
All times are GMT -6. The time now is 08:17 AM. |
Linear Mode
