AutoScrub and Iron-X Clear Bra

Discussion in 'Pre Wash, Wash, Decon, Claying, Engine, Wheels, an' started by Zileas, May 23, 2015.

  1. Zileas

    Zileas New Member

    Has anyone had experience with using NanoSkin AutoScrub and / or Iron-X type fallout remover on a clear bra (Paint Protection Film), specifically Xpel or SunTek?
     
  2. flatstick

    flatstick Birth of a Detailer

    I have Xpel on my ride and I have used clay before on ppf and have had no issues. if I were going to use nanoscub I would go with the towel or mitt .
     
  3. XPEL

    XPEL New Member

    Zileas,

    I looked up the MSDS for Iron-x [SIZE=14pt]and it seems to be safe for film. [/SIZE][SIZE=14pt]Once the film is applied you can use detailing products, as long as they do not contain naphtha or kerosine. [/SIZE]

    [SIZE=14pt]As far as the Nanoskin autoscrub, aka clay bar towel. It is fine for XPEL[/SIZE]

    [SIZE=14pt]Regards,[/SIZE]

    [SIZE=14pt]Benjamin Kenney[/SIZE]
    [SIZE=14pt]Brand Ambassador[/SIZE]
    [SIZE=14pt]XPEL TECHNOLOGIES Corp.[/SIZE]
     

Share This Page